2007 Mercedes-benz Vito

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive BOTH SIDES (5.3.6 (a) (i))

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Suspension component mounting prescribed area is corroded but not considered excessive ON MULTIPLE AREAS FRONT AND REAR (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength 3x holes (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust mounting defective (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive holed but outside 30cm (5.3.6 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Headlamp lens slightly defective both misting (4.1.1 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Brake pedal not releasing correctly (1.1.2 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

hand brake performance low slight creep on footbrake

Brake pedal not releasing correctly (1.1.2 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

hand brake performance low slight creep on footbrake

corrosion to underside of vehicle

Rear Service brake fluctuating, but not excessively both sides (1.2.1 (e))

front jacking points corroded

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pedal creeps down when held under pressure (3.3.B.1a)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear coil spring broken (2.4.C.1a)

Parking brake lever has no reserve travel (3.1.6b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

engine management light on

exhaust tail pipe corroded

Nail in nearside front tyre

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)