2008 Toyota Prius

Front Brake disc worn, pitted or scored, but not seriously weakened Both sides (1.1.14 (a) (ii))

Suspension component corroded but not seriously weakened Front&Rear (5.3.3 (b) (i))

Rear Brake disc significantly and obviously worn Both sides (1.1.14 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick Both sides (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened Both sides (1.1.14 (a) (ii))

Suspension component corroded but not seriously weakened Front&Rear (5.3.3 (b) (i))

corrosion underside to control arms, rear axle, rear inner/outer sill areas

Engine MIL inoperative or indicates a malfunction inoperative (8.2.1.2 (h))

Nearside Headlamp aim projected beam image is obviously incorrect lens deteriorated (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect lens deteriorated (4.1.2 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced throughout underside of vehicle (6.1.1 (c) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Suspension arm corroded but not seriously weakened both front (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened n/s and o/s front arms (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced sill areas to n/s and o/s of vehicle underside (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced n/s and o/s rear around the rear axle beam mounting points (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded where it enters the rear flexible hose (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded where it enters the flexible hose (1.1.11 (c))

Front Suspension arm corroded but not seriously weakened n/s and o/s front arms (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced sill areas to n/s and o/s of vehicle underside (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced n/s and o/s rear around the rear axle beam mounting points (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material front and rear

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)