MOT Status
ExpiredMileage
124,835 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Front Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive SILL (5.3.6 (a) (i))
Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Parking brake inoperative on one side (1.4.1 (a))
Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
corrosion to underside
covers on underside stopping a 100% inspection
has had welding cannot inspect as its full of underseal
Offside Front Brake pipe excessively corroded (1.1.11 (c))
Offside Rear Brake pipe excessively corroded (1.1.11 (c))
Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
corrosion to underside
covers on underside stopping a 100% inspection
has had welding cannot inspect as its full of underseal
Front Brake hose has slight corrosion to ferrule n/s and o/s front (1.1.12 (f) (i))
Front Brake pipe corroded, covered in grease or other material n/s and o/s front (1.1.11 (c))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Front n/s and o/s front steering rack ends and track rod ends corroded
Front water pipe corroded leaking under front bumper
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))
sill cover and floor covers on under side can not fully inspect
Nearside Rear Lower Suspension arm pin or bush excessively worn inner and outer bushes (5.3.4 (a) (i))
Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))
Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))
Offside Rear Lower Suspension arm pin or bush excessively worn inner and outer bushes (5.3.4 (a) (i))
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))
Front water pipe corroded leaking under front bumper
Front n/s and o/s front steering rack ends and track rod ends corroded
Front Brake hose has slight corrosion to ferrule n/s and o/s front (1.1.12 (f) (i))
Front Brake pipe corroded, covered in grease or other material n/s and o/s front (1.1.11 (c))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))
sill cover and floor covers on under side can not fully inspect
Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))
Offside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS
Central Rear Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))
Nearside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))
Front Inner Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))
Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))
Rear Coil spring corroded both sides (5.3.1 (b) (i))
Rear Registration plate deteriorated but not likely to be misread (0.1 (b))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
temp fuel cap fitted
Rear coil spring corroded both sides (2.4.C.1b)
Rear registration plate deteriorated but not likely to be misread (6.3.1d)
temp fuel cap fitted,sealing type
Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Rear coil spring corroded both sides (2.4.C.1b)
Rear registration plate deteriorated but not likely to be misread (6.3.1d)
temp fuel cap fitted,sealing type
engine covers fitted
offside front tyre is wearing on the inside edge
sill covers fitted
under-trays fitted
Nearside Rear Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)
Offside Rear Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)
Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
engine covers fitted
offside front tyre is wearing on the inside edge
sill covers fitted
under-trays fitted
Engine covers fitted obscuring some components in the engine bay
Rear Tyre worn close to the legal limit (4.1.E.1)
Under-trays fitted obscuring some underside components
slight play n/s/r hub
Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS
Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS
Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Track rod end loose (2.2.B.1d)
Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
front bumper damaged
Offside Headlamp aim too low (1.8)
Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Power steering malfunctioning (2.3.3a)
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Jaguar S-type?
Based on 942,176 MOT tests across 62,116 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
WP55 BYG is a 2006 Jaguar S-type in Blue with a 2,720cc diesel engine. This vehicle has been through 26 MOT tests with a personal pass rate of 65.4%.
Across all 2006 Jaguar S-type models, the average MOT pass rate is 78.1% with a typical mileage of 73,291 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Jaguar S-type fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 43,168 recorded failures. If you're considering buying WP55 BYG, it's worth having these areas checked by a mechanic before committing.
The Jaguar S-type typically stays on UK roads for around 27 years. At 20 years old, this Jaguar S-type is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of WP55 BYG?
You can check the full history of WP55 BYG by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was WP55 BYG registered?
WP55 BYG is a 2006 Jaguar S-type, first registered on 21 February 2006.
Is WP55 BYG safe to buy?
The MOT history for WP55 BYG shows 26 tests with a 65.4% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does WP55 BYG have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on WP55 BYG. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.