2007 Mitsubishi Shogun

Front Exhaust mounting defective exhaust bracket broken (6.1.2 (a))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Shock absorbers has slight external damage to the casing both corroded (5.3.2 (b))

Spare tyre defective ()

both side steps corroded

mill light on

rear fuel pipe slight seepage

underside corroded

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower inner under sill (5.3.6 (a) (i))

Front Exhaust mounting defective exhaust bracket broken (6.1.2 (a))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Shock absorbers has slight external damage to the casing both corroded (5.3.2 (b))

Spare tyre defective ()

both side steps corroded

mill light on

rear fuel pipe slight seepage

underside corroded

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic braking system warning device indicates a fault (1.7 (b))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Inner Fuel pipe damaged wing (6.1.3 (c) (ii))

Offside Rear Inner Fuel pipe insecure wing (6.1.3 (a) (i))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

under sided rusted

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Play in steering rack inner joint(s) ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides trailing arm front bush (5.3.4 (a) (i))

both rear wheel archs under door trims corroded

engine oil level over full

os inner sill under car corroded

osf door check strap missing

osf wiper split at end

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill by rear axle tie rod mount (5.3.6 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Play in steering rack inner joint(s) ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides trailing arm front bush (5.3.4 (a) (i))

both rear wheel archs under door trims corroded

engine oil level over full

os inner sill under car corroded

osf door check strap missing

osf tyre bald on inside edge

osf wiper split at end

Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction (3.1 (a) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

osf door check strap missing

rear registration plate lamps insecure

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill by tie rod mount (5.3.6 (a) (i))

osf door check strap missing

rear registration plate lamps insecure

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside inner sills (5.3.6 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside inner sills (5.3.6 (a) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside front tyre wearing on edges

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside rear tyre has a cut on inner edge not deep enough to reach plys or cords

Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front tyres wearing on inner edges

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside rear tyre has a cut on inner edge not deep enough to reach plys or cords

Emissions not tested (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

front tyres worn on inside edges

Front Brake pad(s) wearing thin (3.5.1g)