2008 Suzuki GZ125

Front Stop lamp not working (4.3.1 (a) (ii))

Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Brake has no recorded effort at a wheel Seized (1.2.1 (a) (ii)) DANGEROUS

Chainguard loose and touching chain

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Suspension rod corroded but not seriously weakened Fork stanchion has rust pits which could cause short seal life (5.3.3 (b) (i))

Front Brake master cylinder defective but brake still operating Not returning (1.1.10 (b) (i))

Front Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Suspension rod corroded but not seriously weakened Fork stanchion has rust pits which could cause short seal life (5.3.3 (b) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front Direction indicator incorrect colour (1.5.1b)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Headlamp aim too low (1.6)

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Wheel alignment slightly misaligned. (2.5.1)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front wheel bearings are excessively rough (2.3.5b)

Headlamp aim too high (1.6)

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Wheel alignment slightly misaligned. (2.5.1)

Drive chain sprocket carrier worn to excess (6.2.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp aim too high (1.6)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Drive chain slightly tight (6.2.1d)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake lever pivots slightly worn (3.1.3a)

Front wheel bearings are slightly rough (2.3.5b)