2006 Toyota Land Cruiser

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin Both (1.1.13 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin Both (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear reflector defective or damaged by more than 50% of the reflecting surface (4.8.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength around chassie mounting (sill) (5.3.6 (a) (i))

Engine covers and under trays fitted to the vehicle.

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside sill corroded

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside sill corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Upper Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Brake load sensing valve inoperative but ABS functioning (1.1.17 (c) (i))

Nearside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit inner edge borderline (4.1.E.1)

Offside Front Tyre worn close to the legal limit borderline (4.1.E.1)

Offside Rear Tyre worn close to the legal limit on edges (4.1.E.1)

uneven wear on both front tyres

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Vehicle's internal headlight adjuster altered to recheck lights

both rear tyres slightly perished

nearside rear tyre slightly perished

offside front tyre worn on edges

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too low and too far to the right. (1.8)

o/s/r tyre worn on both edges, outer edge bald

Nearside Front Headlamp aim too low (1.8)