2012 Fiat Panda

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim projected beam image is obviously incorrect (no pattern) (4.1.2 (c))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Suspension component corroded but not seriously weakened Axle (5.3.3 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Brake pipe corroded, covered in grease or other material FRONT AND REAR (1.1.11 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive ENGINE SUMP LEAKING (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge tread (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge tread (5.2.3 (e))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust mounting defective center section mounting corroded away but exhaust still adequately supported (6.1.2 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn to 1.7mm (legal limit 1.6mm) and bald on inner edge no cords exposed at time of test (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorber has a slightly worn bush (2.7.4)