2002 Nissan Navara

Central Prop shaft joint worn, but not excessively center bearing worn (6.1.7 (c) (i))

Front Lower Suspension arm ball joint has slight play n/s and o/s (5.3.4 (a) (i))

Front Wheel bearing has slight play n/s and o/s (5.1.3 (a) (i))

Rear rear brakes slightly binding

Nearside Front tyre worn inner edge

Offside Rear light lens broken

chassis, body, tow bar and suspension components corroded

front to rear brake pipes corroded /and on load valve

fuel pipe corroded

slight play center prop shaft bearing

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Bumper insecure bracket broken (6.1.4 (a) (i))

Offside Front Floor excessively deteriorated corrosion (6.2.4 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill, next to body mount (6.1.1 (c) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill end cap (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outrigger above axle (5.3.6 (a) (i))

Offside Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe corroded, covered in grease or other material both front to rear at load valve (1.1.11 (c))

Central Prop shaft bearing has slight play (6.1.7 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Wheel bearing has slight play both sides (5.1.3 (a) (i))

Fuel Pipe/s corroded ()

Nearside Front Tyre worn close to legal limit/worn on edge wearing on inner edge 255-70-16 (5.2.3 (e))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill end cap (6.2.2 (d) (i))

Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

chassis, suspension units and mountings, body mountings corroded

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Battery insecure (1.9.1)

Exhaust system not adequately supported Rear silencer (7.1.1)

Nearside Front Fluid suspension unit totally deflated (2.4.D.1a)

Nearside Front Fluid suspension unit totally deflated (2.4.D.1a)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Brake pipe slightly corroded all (3.6.B.2c)

Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

corrshion allover

Nearside Rear Service brake grabbing severely (3.7.C.2)

Offside Rear Service brake grabbing severely (3.7.C.2)

Brake pipe slightly corroded all (3.6.B.2c)

Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

corrshion allover

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

chassis and suspension corroded

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside CV joint noisy.

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Surface corrosion all over underside of vehicle.

Centre Upper Stop lamp not working (1.2.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Registration plate lamp not fitted (1.1.C.1b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside CV joint noisy.

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Surface corrosion all over underside of vehicle.

vehicle chassis section starting to rust and rear bumber and brakepipe are underseald

slight rust on centre silencerbox

rear silencerbox starting to rust

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen wiper blade deteriorated (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)