2003 Gilera Cougar

Drive chain slightly tight (6.2.1d)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front brake lever fouling switch casing.

L plate fouling front mudguard.

Play in swinging arm bearings.

Riders l/h footrest bent.

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Headlamp aim too far to the right (1.6)

Nearside Rear Footrest missing (6.2.1a)

Drive chain slightly tight (6.2.1d)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front brake lever fouling switch casing.

L plate fouling front mudguard.

Play in swinging arm bearings.

Riders l/h footrest bent.

Exhaust excessively deteriorated (7.1.1a)

Exhaust is leaking and excessively noisey (7.1.1b)

Front Roller brake test indicates a binding brake (3.3.A1a)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Nearside Front Direction indicator flashing less than 60 times a minute (1.5.1c)

Nearside Rear Direction indicator not working (1.5.1c)

Nearside Rear Footrest missing (6.2.1a)

Nearside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Offside Front Direction indicator flashing less than 60 times a minute (1.5.1c)

Offside Front Direction indicator not working (1.5.1c)

Offside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Stop lamp remains on when the brake is released (1.3.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii)) DANGEROUS

Handlebar mounting clamp bolt loose (2.1.1a) DANGEROUS

Handlebar mounting excessively deteriorated (flexible type) (2.1.1d) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii)) DANGEROUS

Throttle operating incorrectly (6.2.1f) DANGEROUS

Chain guard missing

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Nearside Upper Front suspension assembly slightly corroded. (2.3.1)

Offside Upper Front suspension assembly slightly corroded. (2.3.1)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Steering headbearing has slight free play (2.2.2)

nearside front footrest bent