2003 Mercedes-benz Vito

Driver's airbag missing (7.1.5 (a))

Nearside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

corrosion to underside including suspension components

edc light on

vehicle suspension lowered

gear stick insecure

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Suspension components corroded but not seriously weakened

Nearside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Front Outer Integral body structure inadequately repaired such that structural rigidity is significantly reduced sill (6.1.1 (d) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill holed (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill holed (6.1.1 (c) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Suspension components corroded but not seriously weakened

under body wax oiled

Front Exhaust mounting defective (6.1.2 (a))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive outer sill lip (7.1.1 (a) (i))

Nearside mirror missing

Offside Suspension component mounting prescribed area is corroded but not considered excessive Jacking point just over 30cm from subframe mount (5.3.6 (a) (i))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt clip loose (6.1.7 (g) (ii))

Offside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive outer sill lip (7.1.1 (a) (i))

Nearside mirror missing

Offside Suspension component mounting prescribed area is corroded but not considered excessive Jacking point just over 30cm from subframe mount (5.3.6 (a) (i))

Nearside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner chassis leg/inner wing (5.3.6 (a) (i))

Central Exhaust heat shield loose

Fuel filler neck shield corroded

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced rear crossmember (6.1.1 (c) (i))

Nearside Rear Seat belt stitching slightly frayed (5.2.2b)

Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Seat belt stitching slightly frayed (5.2.2b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Nail in tyre and perishing and wearing on inner edge ()

Nearside Rear Seat belt stitching slightly frayed (5.2.2b)

front exhaust rubber broken

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Outer Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Side repeater incorrect colour (1.4.A.2f)

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Nail in tyre and perishing and wearing on inner edge ()

Nearside Rear Seat belt stitching slightly frayed (5.2.2b)

front exhaust rubber broken

Nearside Obligatory mirror deteriorated, but not seriously affecting the rear view (8.1.2a)

exhaust heat shield insecure

nearside rear tyre outer sidewall perishing

Nearside Obligatory mirror deteriorated, but not seriously affecting the rear view (8.1.2a)

Offside Front position lamp(s) not working (1.1.A.3b)

exhaust heat shield insecure

nearside rear tyre outer sidewall perishing

Oil leak

n/s door mirror glass selotaped on

n/s inner front cv gaitor detiriorated

front reg damaged

Offside Front Brake hose excessively chafed (3.6.B.4d)

Offside Inner Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front reg damaged

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

brake fluid level low

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i) DANGEROUS

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Seat belt insecurely fixed to the seat (5.2.1a)

Rear Seat belt locking mechanism does not secure or release (5.2.5a)

brake master cylinder fluid level low