2005 Mitsubishi Lancer

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Fuel Pipe/s corroded ()

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Fuel Pipe/s corroded ()

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm to body both (5.3.4 (a) (i))

Nearside Rear Brake pipe slightly corroded front to back in clips (3.6.B.2c)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Headlamp aim too high Both too high (1.8)

Nearside Rear Brake pipe slightly corroded front to back in clips (3.6.B.2c)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Tyre worn close to the legal limit both front tyres inner edge (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights

Nearside Rear Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights

Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

clutch slipping

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

clutch slipping

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

object in nsf tyre

power steering pipe damp with fluid

steel rim fitted to osf

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)