2006 Ktm 125 Exc

Chain guard missing ()

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

no usable lighting fitted at time of test

Front Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) DANGEROUS

Rear Brake caliper insecurely mounted and braking performance affected (1.1.16 (c) (ii)) DANGEROUS

Rear Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) DANGEROUS

Chain guard missing ()

Fuel system component leaking carb (6.1.3 (b) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Horn not working (7.7 (a))

Rear Position lamp not working (4.2.1 (a))

Rear Tyre is unsuitable (5.2.3 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Chain guard missing ()

Chain guard missing ()

Exhaust noisy (8.1.1 (a))

Nearside Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Offside Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Upper Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

no stand fitted

no usable lighting fitted at time of test

Headlamp aim too high (4.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Steering linkage locking device ineffective (2.1.3 (d))

Offside Front Steering linkage locking device ineffective (2.1.3 (d))

Rear Brake caliper insecure (1.1.16 (c) (i))

Rear Position lamp not working (4.2.1 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements incorrect angle (0.1 (d))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp not working (4.3.1 (a) (ii))

Chain guard missing ()

Exhaust noisy (8.1.1 (a))

Nearside Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Offside Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Upper Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

no stand fitted

Front Wheel spoke slightly loose. (4.2.1b)

No lights fitted daytime use only

Rear Rear wheel bearings have slight free play (2.4.A.2c)

Rear Wheel spoke slightly loose. (4.2.1b)

Front Front wheel bearings are slightly rough (2.3.5b)

Headlamp aim too high (1.6)

Nearside Rear Wheel spoke slightly loose. (4.2.1b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Front wheel bearings are slightly rough (2.3.5b)

Nearside Rear Wheel spoke slightly loose. (4.2.1b)

Drive chain worn but not considered excessive (6.2.1e)

Front Drive chain sprocket slightly worn (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Front wheel bearings have excessive free play (2.3.5b)

Rear Rear wheel bearings have excessive free play (2.4.A.2c)