2004 Mercedes-benz Vito

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge worn outer edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive both sides outer jacking points (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both sides outer sill panels (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge worn outer edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive both sides outer jacking points (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both sides outer sill panels (5.3.6 (a) (i))

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

BOTH REAR INNER AND OUTER SILLS SLIGHTLY CORRODED.

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)