2006 Citroen Relay

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Nail in tyre ()

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear outer rigger excess corrosion

Nearside inner sill excess corrosion

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear outer rigger excess corrosion

Oil leak, but not excessive (8.4.1 (a) (i))

front and rear tyres different sizes

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn inner bush worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Nail in tyre ()

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear outer rigger excess corrosion

Nearside inner sill excess corrosion

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear outer rigger excess corrosion

Oil leak, but not excessive (8.4.1 (a) (i))

front and rear tyres different sizes

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside inner sill area corrosion

Offside Front Nail in tyre ()

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

front radiator lower cross member / excess corrosion

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Rear Suspension component mounting prescribed area is inadequately repaired chassis area / close to spring eye (suspension) (5.3.6 (a) (i))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside inner sill area corrosion

Offside Front Nail in tyre ()

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

front radiator lower cross member / excess corrosion

Offside Front outer part of jacking point holed and corroded

inner sills, floor section braces, rear body inner panel holed and corroded

radiator support panel holed and corroded

Emissions not tested (8.2.2.2 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear most spring hanger bracket (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength upper strut box section (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front outer part of jacking point holed and corroded

inner sills, floor section braces, rear body inner panel holed and corroded

radiator support panel holed and corroded

axle weight plate loose

floor strut, rear inner valance panel and inner sills corroded and holed

radiator support panel corroded

Nearside Front Lower Suspension arm pin or bush excessively worn forward most (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

axle weight plate loose

floor strut, rear inner valance panel and inner sills corroded and holed

radiator support panel corroded

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake hose slightly damaged (1.1.12 (b) (i))

floor X-member holed and corroded just outside prescribed area

non structural rear X-member holed and corroded

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction lift up note pad and phone holder (3.1 (a) (ii))

Emissions not tested oil below minimum (8.2.2.2 (e))

Nearside Rear Brake prescribed area is excessively corroded comp valve mounting (1.1.21 (e) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Nearside Rear Leaf spring shackle bracket insecure to the extent that relative movement is visible (5.3.1 (a) (ii)) DANGEROUS

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake hose slightly damaged (1.1.12 (b) (i))

floor X-member holed and corroded just outside prescribed area

non structural rear X-member holed and corroded

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive 32cm (2.4.A.3)

Rear body panel not structural corroded and holed

vin plate missing axle weights from autodata

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive 32cm (2.4.A.3)

Rear body panel not structural corroded and holed

vin plate missing axle weights from autodata

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

rear body panel corroded

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Macpherson strut corroded and seriously weakened upper mount (2.4.G.1)

Offside Front Macpherson strut corroded and seriously weakened upper mount (2.4.G.1)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement rearmost (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Steering system excessively tight (2.2.D.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' sat nav holder (8.3.1e)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

rear body panel corroded

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

rear tyres perished

Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front Electrical wiring inadequately supported (1.9.2a)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

rear tyres perished

several books on dash obstructing drivers view were removed before test

Nearside Rear Leaf spring fractured (2.4.B.1a)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

several books on dash obstructing drivers view were removed before test

exhaust makes an annoying rattle/sqeak on tickover

offside front tyre on legal limit

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp aim too low (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp aim beam image kick up to the offside (1.8)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)