2007 Subaru Legacy

Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Inner Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)