2003 Fiat Doblo

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Brake performance not tested brake pipe leaking at rear (1.2.1 (g))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Rear Brake pipe excessively corroded all at the limiting valve (1.1.11 (c))

Rear Brake pipe leaking on an air braking system at the limiting valve (1.1.11 (b) (i))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material to the hose (1.1.11 (c))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to the hose (1.1.11 (c))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Upper Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

o/s/r tyre sidewalls perished/cracked.

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front Upper Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

o/s/r tyre sidewalls perished/cracked.

Spare tyre defective

nearside rear tyre starting to perish

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Brake master cylinder fluid level below minimum level (3.6.G.1e) DANGEROUS

Nearside Rear Braking system leaking (3.6.A.1) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Position lamp switch faulty (1.1.A.1)