2006 Fiat Ducato

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Both front shock absorber shaft corroded at top

Both front top suspension mounts feel notchy

Exhaust silencer outer skin corroded and adrift

Front Coil spring corroded Both (5.3.1 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material Marked (1.1.11 (c))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material Marked (1.1.11 (c))

Offside Front Headlamp lens has condensation inside

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Offside Front Upper Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension arm pin or bush excessively worn Wishbone front bush. (5.3.4 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Suspension arm pin or bush excessively worn Wishbone front and rear bush. (5.3.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Central Exhaust silencer corroded.

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front P.A.S rack pipes corroded.

Front Windscreen damaged but not adversely affecting driver's view Small stone chip. (3.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced Sill holed/corroded. (6.1.1 (c) (i))

Offside Front Upper Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Sill holed/corroded. (6.1.1 (c) (i))

advise inner sills corroded and holed but not in prescribed areas

Front Brake pipe excessively corroded across bulkhead (3.6.B.2c)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting crossmember (6.6.6)

Offside Front Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension spring mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting crossmember (6.6.6)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

advise inner sills corroded and holed but not in prescribed areas

Vehicle structure has slight corrosion (6.1.A.1)

corrosion outside prescribed areas

metal clutch pipe corroded

Front Brakes imbalanced across an axle (3.7.B.5b)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Rear Brake load sensing valve defective and function impaired (3.6.E.3)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Vehicle structure has slight corrosion (6.1.A.1)

corrosion outside prescribed areas

metal clutch pipe corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front front brake fluctuating, but not excessively (3.7.B.3)

nearside front tyre tread cracked

offside front tyre tread cracked

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

center stop lamp damaged

Centre Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

center stop lamp damaged

slight damage to drivers door mirror

Nearside rear brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Rear Brake load sensing valve linkage seized (3.6.E.3)

slight damage to drivers door mirror

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Front Brake pad(s) wearing thin (3.5.1g)