2007 Mercedes-benz Vito

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

offside front macpherson strut top mount making slight noise when turning

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

offside front macpherson strut top mount making slight noise when turning

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component ball joint has slight play Both front (5.3.4 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength osr sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component ball joint has slight play Both front (5.3.4 (a) (i))

Front Brake pipe corroded, covered in grease or other material Both under arches, rusty (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material rusty (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both rear wishbones front mountings @ jacking points (5.3.6 (a) (i))

handbrake only just met, n/s low

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both under arches, rusty (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material rusty (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both rear wishbones front mountings @ jacking points (5.3.6 (a) (i))

handbrake only just met, n/s low

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive spring (5.3.6 (a) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Oil leak, but not excessive diff (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear suspension front wishbone mounting (5.3.6 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Headlamp aim too low both (4.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive spring (5.3.6 (a) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Oil leak, but not excessive diff (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear suspension front wishbone mounting (5.3.6 (a) (i))

Oil leak, but not excessive rear diff (8.4.1 (a) (i))

corrosion to underside of vehicle

corrosion to underside of vehicle

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Oil leak, but not excessive axle (8.4.1 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced on jacking pionts (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced on jacking pionts (6.1.1 (c) (i))

Rear Oil leak, but not excessive on drive shaft seal both (8.4.1 (a) (i))

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Seat belt locking mechanism does not secure or release reciever (5.2.5a)

EML ON

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Front Seat belt insecurely fixed to the seat (5.2.1a)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS

EML ON

Rear Brake pad(s) wearing thin (3.5.1g)

brake pad warning light on

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

engine management light on

Nearside front brake binding (3.7.B.1)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

engine management light on

Brake pad warning light on

Brake pedal creeps down when held under pressure (3.3.B.1a)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Rear position lamp(s) not working (1.1.A.3b)

Bonnet cable faulty

Brake pad warning light on

Offside Rear coil spring fractured (2.4.C.1a)

front brake juddering severely (3.7.A.2b)

Bonnet cable faulty

Brake pad warning light on