2008 Yamaha Yzf

brake fluid reservoir contaminated with brake fluid

clutch lever pivot worn

exhaust system noisey

front brake lever pivot worn

gear lever pivot worn

headlight has poor patern

o/s foot rear retain clip missing

rear pillion seat missing/foot pegs still not fitted

rear registration plate detriorated

fairing panels insecure

Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Headlamp aim too low (4.1.2 (a))

Headlamp insecure (4.1.1 (c))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Footrest missing (6.2.12 (a))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

brake fluid reservoir contaminated with brake fluid

clutch lever pivot worn

exhaust system noisey

front brake lever pivot worn

gear lever pivot worn

headlight has poor patern

o/s foot rear retain clip missing

rear registration plate detriorated

fairing panels insecure

Drive chain worn to excess (6.2.1e)

Front shock absorber seal failed and leaking oil (2.3.3)

Nearside Rear Footrest missing (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Exhaust noisy (7.1.2)

Rear mono-shock pivot worn but not excessive (2.4.B.4)

Rear Brake fluid reservoir fluid level low (3.2.B1d)

crack in numberplate

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Rear Brake fluid reservoir fluid level low (3.2.B1d)

crack in numberplate

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake pads are close to the minimum requirement of 1mm.