2013 Fiat Doblo

Front Oil leak, but not excessive engine oil (8.4.1 (a) (i))

Nearside Front Oil leak, but not excessive driveshaft seal (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both rear tyres (5.2.3 (e))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Horn not working (7.7 (a))

Oil leaking excessively from engine engine sump corroded (8.4.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases exhaust flexi deteriorated (6.1.2 (a))

Brake pipe corroded, covered in grease or other material all metal pipes (1.1.11 (c))

Front Exhaust has a minor leak of exhaust gases flexi pipe (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases back box strong advise (6.1.2 (a))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Front Registration plate inscription illegible (0.1 (b))

Horn not working (7.7 (a))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i))

Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill split 30cm from rear axle mount. (6.2.2 (d) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Shock absorbers has a serious fluid leak Fluid has leaked and dried up on shocker casing. (5.3.2 (b))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Exhaust pipe not secured in its rubber mount.

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Windscreen washer not working (3.5 (a))

Windscreen wiper not working (3.4 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Stop lamp(s) all not working (4.3.1 (a) (iii))