2013 Mercedes-benz Sprinter

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, but not excessively Near side and off side (1.1.14 (a) (i))

Front Lower Suspension arm ball joint has slight play Near side and off side (5.3.4 (a) (i))

Front Suspension arm ball joint has slight play Both (5.3.4 (a) (i))

Handbrake travel high

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm ball joint has slight play Both (5.3.4 (a) (i))

Handbrake travel high

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside slight damage to central panel

low emissions no print produced

Play in steering rack inner joint(s)

Windscreen damaged but not adversely affecting driver's view chip (3.2 (a) (i))

Offside Rear Lower Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working side light (4.2.1 (a))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Play in steering rack inner joint(s)

Windscreen damaged but not adversely affecting driver's view chip (3.2 (a) (i))

emissions too clean to register

Brake pad(s) less than 1.5 mm thick rear inner brake pads (3.5.1g)

brake warning light on

emissions too clean to register

Parking brake lever has little reserve travel (3.1.6b)

cuts in n/s/r tyre

Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake lever has little reserve travel (3.1.6b)

cuts in n/s/r tyre