2014 Fiat Doblo

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage damaged and seriously weakened damaged and detached (5.3.3 (b) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Headlamp lens slightly defective + reflector (4.1.1 (b) (i))

Upper Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Headlamp aim too low both sides (4.1.2 (a))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Headlamp lens slightly defective + reflector (4.1.1 (b) (i))

Upper Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively both sides (3.4 (b) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Macpherson strut pin or bush excessively worn (5.3.4 (a) (i))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake pedal anti-slip provision missing (1.1.2 (c))

Offside Front Side repeater lens defective such that the emitted light is adversely affected (4.4.1 (b) (ii))

Offside Rear Lower Rear reflector missing (4.8.2 (a) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)