2003 Peugeot Boxer

Exhaust has a minor leak of exhaust gases egr pipe to manifold, has slight blow, no fumes entering cab at time of test, advise repair (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material both sides all coated in underseal (inner arches) (1.1.11 (c))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering pipe/hose slightly corroded coated in grease on rack (2.1.5 (g) (i))

Tyre obviously under inflated spare wheel (5.2.3 (l))

all general underbody and component corrosion

vehicle corroded/holed in areas outside of 30cm component radius, however advise repair, both front chassis legs (cross member mounting)

Brake performance unable to be tested due to n/s/r brake binding (1.2.1 (g))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Brake pipe likely to become detached or damaged bracket snapped away from chassis (1.1.11 (d) (ii))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded and functionality of the braking system is affected inner arch (1.1.21 (e) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material both sides all coated in underseal (inner arches) (1.1.11 (c))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering pipe/hose slightly corroded coated in grease on rack (2.1.5 (g) (i))

Tyre obviously under inflated spare wheel (5.2.3 (l))

all general underbody and component corrosion

vehicle corroded/holed in areas outside of 30cm component radius, however advise repair, both front chassis legs (cross member mounting)

Exhaust has a minor leak of exhaust gases front join after turbo, also tailbox outer skin of metal corroded/deteriorated (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material both too flexi hoses (1.1.11 (c))

Oil leak, but not excessive transmission (o/s drive shaft seal) (8.4.1 (a) (i))

all general component corrosion

all general underbody corrosion, included hole at o/s/r of cab and o/s/f cross member area, outside of 30cm of component radius

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner arch/chassis (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength jacking point/chassis (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch/strut turret (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner arch/chassis (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength jacking point/chassis (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch/strut turret (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material both along chassis, too flexi hoses (1.1.11 (c))

Offside Oil leak, but not excessive drive shaft seal on gearbox (8.4.1 (a) (i))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning 1 of 2 lamps not working (4.2.1 (a) (i))

all other general component corrosion

all other underbody/chassis corrosion (body holed o/s/r of cab and o/s/f cross member, outside of 30cm radius, advise repair

outdoor step to living area of camper insecure too wooden floor, not considered likely to fall from vehicle, however advise repair

Front Inner wheel arches corrosion present

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced jacking point (6.1.1 (c) (i))

Offside Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced jacking point (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Axle beam corroded

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Front chassis legs corroded

Front jacking points corrosion present

Nearside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing / arch (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing / arch (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Sub-frame corroded and seriously weakened n/s/f (2.4.G.1)

Subframe mounting prescribed area is excessively corroded n/s&o/s subframe mounts (2.4.A.3)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

center exhaust box outer covering and exhaust hangers corroded

corrosion n/s o/s front chassis around subframe mounting points

n/s rear upper stop light not working

surface corrosion n/s front under step sill area

Nearside rear brake binding (3.7.B.1)

o/s rear brake binding slightly

Nearside Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)