2004 Honda Vt 125 C-4

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp aim too high (4.1.2 (a))

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Tyre worn close to the legal limit (5.2.3 (e))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Steering headbearing slightly stiff or notchy Slightly notchy (2.2.2 (f) (i))

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Front Brake lever insecure Brake securing clamp loose! (1.1.2 (e) (i))

Rear Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Nearside Rear Shock absorber missing (5.3.2 (a) (ii)) DANGEROUS

Offside Rear Shock absorber missing (5.3.2 (a) (ii)) DANGEROUS

Rear Drive chain so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Clutch lever securing nut missing!

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Steering headbearing slightly stiff or notchy Slightly notchy (2.2.2 (f) (i))

Exhaust is leaking but is not excessively noisey (7.1.1b)

Exhaust slightly deteriorated (7.1.1a)

h/bars slightly bent

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Roller brake test indicates a binding brake (3.3.A1a)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear Brake pedal has inadequate reserve travel (3.1.3b)

Rear reflector on motorcycle obscured (1.4.1)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Drive chain excessively tight (6.2.1d)

Front Brake disc(s) excessively worn (3.2.A1l)

Nearside Rear Direction indicator not working (1.5.1c)

Rear Brake pedal is inoperative (3.1.3c)

Rear Roller brake test indicates a sticking brake (3.3.A1a)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b) DANGEROUS

Rear Floor brake test indicates a binding brake (3.3.C2c)

gear linkage has slight play in bushes

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake disc(s) is slightly distorted (3.2.A1m)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))