2005 BMW X5

Front Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

covers and shields fitted obscuring view of components

Nearside Front Suspension arm has slight play in a ball joint Rear arm (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension arm has slight play in a ball joint Rear arm (2.4.G.2)

offside rear 1 of 2 sidelight not working

Offside Front Suspension arm has excessive play in a ball joint rear arm (2.4.G.2)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

offside rear 1 of 2 sidelight not working

front tyres worn on edges

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pad(s) wearing thin (3.5.1g)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

both rear tyres on 3mm and wearing on inner edge

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)