2006 Fiat Ducato

Brake load sensing valve linkage tight

Front Subframe mountings quite badly corroded

Front brake hose ferrules corroded

Front chassis rotten with corrosion, not within suspension prescribed areas

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Service brake binding but not excessively, n/s/f and o/s/r. Rear brake pads heat damaged

Vehicle 340kg over GVW and 250kg over max rear axle weight

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake load sensing valve linkage tight

Front Subframe mountings quite badly corroded

Front brake hose ferrules corroded

Front chassis rotten with corrosion, not within suspension prescribed areas

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Vehicle 600kg over GVW and 500kg over max rear axle weight

All four front brake hose ferrules are corroded, the n/s/f lower quite badly

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front cross member and engine mounting area corroded

Central Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Exhaust system insecure (6.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 215/75r16c (5.2.3 (d) (i))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

All four front brake hose ferrules are corroded, the n/s/f lower quite badly

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front cross member and engine mounting area corroded

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Outline marker lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate does not conform to the specified requirements - Not readable, item blocking view (0.1 (d))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Front Items removed from driver's view prior to test ()

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Towbar obstructing the registration plate so that it is unreadable (bike rack) (6.1.6 (f) (ii))

Nearside Rear Towbar obstructing a lamp due to bike rack (6.1.6 (f) (i))

Offside Rear Towbar obstructing a lamp (6.1.6 (f) (i))

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has little reserve travel (3.1.6b)

o/s washers aim low on screen

corroded electrical connectors under bonnet

tracking set/adjust required ASAP

Nearside Headlamp aim too low (1.8)

Offside Front Track rod end loose (2.2.B.1d)

Offside Headlamp aim too low (1.8)

corroded electrical connectors under bonnet

tracking set/adjust required ASAP