2002 Honda Jazz

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Inner rear bush. (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Inner rear bush. (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge Both Front (5.2.3 (e))

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Bumper insecure ()

Offside Rear Brake pipe slightly corroded both pipes (3.6.B.2c)

Rear Brake hose has slight corrosion to ferrules both sides (3.6.B.4e)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Inner Subframe mounting prescribed area is corroded but not considered excessive both sides (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear coil spring corroded both sides (2.4.C.1b)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine management light on

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Body has a sharp edge caused by damage (6.1.C.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine management light on

Front Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Centre Stop lamp not working (1.2.1b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Offside Stop lamp not working (1.2.1b)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Front suspension has excessive play in a track control arm inner bush (2.5.B.2b)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front suspension has excessive play in a track control arm inner bush (2.5.B.2b)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)