2002 Mercedes-benz Clk

Windscreen washer provides insufficient washer liquid (3.5 (a))

Indicator switch faulty (4.4.2 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

n/s/r bumper damaged, but not likely to cause injury

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Indicator switch faulty (4.4.2 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

n/s/r bumper damaged, but not likely to cause injury

Nearside Front Tyre worn close to legal limit/worn on edge Worn on both edges (5.2.3 (e))

Offside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge Worn on both edges (5.2.3 (e))

Offside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Headlamp cleaning device inoperative (1.7.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

front brake application uneven (3.7.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Covers under vehicle

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Covers under vehicle

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

brake pad warning light on

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Plastic covers on underside and sills restricting examin ation.

Nearside Front coil spring cracked (2.4.C.1a)

Offside Front coil spring cracked (2.4.C.1a) DANGEROUS

Offside Headlamp aim too low (1.8)

Plastic covers on underside and sills restricting examin ation.

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc excessively pitted (3.5.1h)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)