2011 BMW 116

Engine cover and under tray fitted obscuring some areas

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Bumper mountings corroded but not likely to become detached damaged (6.1.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

windscreen washers weak

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp aim too low and too far to the right. (4.1.2 (a))

windscreen washers weak

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Body has a sharp edge caused by damage headlamp lens (6.1.C.1)

Nearside Front Headlamp aim not tested (1.8.A.1c)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)