2000 Subaru Legacy

Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear coil spring corroded (2.4.C.1b)

Rear exhaust box is corroded

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

EXHAUST IN POOR CONDITION

N/S/F WHEEL RIM DAMAGED ON THE INNER EDGE

O/S/F TYRE IS WORN ON THE INNER EDGE

O/S/R SHOCK ABSORBER LEAKING !!

REAR TRAILING ARM BUSHES ARE STARTING TO PEREISH

COIL SPRINGS RUSTY

EXHAUST RUSTY

N/S/F TYRE IS ON LEGAL LIMT,O/S/F GETTING LOW

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

all tyres wearing

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

all tyres wearing

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)