2000 Honda Cr-v

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Windows don’t work

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Windows don’t work

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded to hub (1.1.11 (c))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Brake pipe excessively corroded to hub (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Registration plate lamp not working (1.1.C.1d)

Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Registration plate lamp not working (1.1.C.1d)

Bonnet cannot be secured in the closed position (8.4.1)

Nearside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

rear exhaust rattle

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

no engine oil.

o/s/f tyre flat.

Bonnet cannot be secured in the closed position (8.4.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Stop lamp not working (1.2.1b)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Registration plate lamp not working (1.1.5c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim too low (1.8)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Registration plate lamp not working (1.1.5c)

Nearside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear Registration plate lamp not working (1.1.5c)

offside front tyre worn on edges near limit

rear exhaust joint heavily carroded