2000 Mazda Bongo

Front Integral body structure is corroded but structural rigidity is not significantly reduced crossmember (6.1.1 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened and offside (1.1.14 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Passenger seat(s) missing at time of test ()

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Nail in tyre ()

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced arch (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced corner panel (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced panel (6.1.1 (c) (i))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Brake performance not tested (1.2.1 (g))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced arch (6.1.1 (c) (i))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced arch (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced corner panel behind bumper (6.1.1 (c) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced corner panel behind bumper (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Fluid leak, but not excessive coolant (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Headlamp lens slightly defective both sides deteriorated (4.1.1 (b) (i))

Front Integral body structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Offside Front Suspension component mounting prescribed area is excessively corroded outrigger (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Inner Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Inner Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Stop lamp not working (1.2.1b)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)