2000 Citroen Berlingo

Brake load sensing valve inoperative (3.6.E.3)

Fuel system component leaking (7.2.3)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Oil leak

Brake load sensing valve seized (3.6.E.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Brake pipe inadequately supported (3.6.B.1)

Service brake: efficiency below requirements (3.7.B.7)

advise n/s/f tyre outer edge wear

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front tyre treads are worn down to limits in places

Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Headlamp aim too low (1.8)

Offside Front Macpherson strut upper support bearing is stiff in operation (2.5.B.1b)

Offside Side repeater incorrect colour (1.4.A.2f)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front tyre treads are worn down to limits in places

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper blade deteriorated (8.2.2)

Offside Front Windscreen wiper blade deteriorated (8.2.2)

rear brake grabbing severely (3.7.A.5b)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

cooling not working †