2000 Toyota Yaris

Nearside Rear Tyre slightly damaged/cracking or perishing sidewall perishing (5.2.3 (d) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength corrosion of a previous repair (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing sidewall perishing (5.2.3 (d) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases pipe (6.1.2 (a))

Fuel Pipe/s corroded ()

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases pipe (6.1.2 (a))

Fuel Pipe/s corroded ()

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive above coil spring (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Windscreen washer not working (3.5 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive above coil spring (5.3.6 (a) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Front exhaust pipe mounting brackets broken off

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front screen washer jet not working

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Brake valve insecurely mounted disconnected/corroded from axle at n/s/r (3.6.A.2a)

Nearside Rear Subframe mounting prescribed area is excessively corroded outer sill near rear axle forward mounting point at floor (2.4.A.3)

Front exhaust pipe mounting brackets broken off

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front screen washer jet not working

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring broken (2.4.C.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)