2000 Ford Fiesta Courier

all front and rear suspension mounts corroded all coil springs corroded general underbody corrosion consistent with vehicle age

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced chassis to floor (7.1.1 (a) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor to chassis (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material all front to rear (1.1.11 (c))

Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure (1.9.1)

Fuel system component leaking injector (7.2.3)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Inner Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Nearside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Offside Inner Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b) DANGEROUS

Nearside Front Brake hose excessively damaged (3.6.B.4d) DANGEROUS

Nearside Front Brake hose inappropriately repaired (3.6.A.3) DANGEROUS

Nearside Rear Brake pipe leaking (3.6.A.1) DANGEROUS

Offside Rear brake pipe to cylinder area is damp not leaking at time of mot

fuel tank is corroded

suspension springs are corroded

oil leak

ALL SUSPENSION COIL SPRINGS ARE CORRODED

NEAR SIDE AND OFF SIDE FORNT LOWER SUSPENSION ARM BUSHES ARE CORRODED

NEAR SIDE AND OFF SIDE OUTER WHEEL ARCHES ARE CORRODED

oil leak

Headlamp switch faulty (1.7.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Inner Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

NEAR SIDE AND OFF SIDE LOWER SUSPENSON ARM BUSHES ARE WORN

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

REAR WHEEL ARCHES ARE CORRODED

SUSPENSON SPRINGS ARE CORRODED

oil leak

NEAR SIDE AND OFF SIDE REAR WHEEL ARCHES ARE CORRODED

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

SUSPENSION COIL SPRINGS ARE CORRODED

Battery insecure (1.9.1)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Fuel system component leaking (7.2.3) DANGEROUS

Offside Front Brake hose excessively deteriorated (3.6.B.4d) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

all suspension coil springs are corroded

near side and off side rear wheel arches are corroded

oil leaking on to exhaust

front brake discs are worn low

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

all under side is heavly under sealed unable to check fully for corrosion

near side front brake pads are worn low

suspension coil springs are corroded

the near side and off side front lower suspension arm bushes are worn

Brake load sensing valve seized (3.6.E.3)

Fuel system component leaking (7.2.3)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Headlamp aim too low (1.8)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

all underside corroded

engine oil leak

front discs worn thin/corroded

Front brake discs corroded

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Brake hose slightly chafed (3.6.B.4d)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Rear exhaust has mount missing but system is adequatley supported

Centre Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Front brake discs corroded

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Brake hose slightly chafed (3.6.B.4d)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Rear exhaust has mount missing but system is adequatley supported

Nearside Outer Body has slight corrosion (6.1.B.2)

Offside Outer Body has slight corrosion (6.1.B.2)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Outer Body has slight corrosion (6.1.B.2)

Offside Outer Body has slight corrosion (6.1.B.2)

Brake load sensing valve linkage seized (3.6.E.3)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

all brake piped have slight surface corrosion, in need of some treatment!

handbrake travel high but not hitting the stop!

Brake load sensing valve linkage seized (3.6.E.3)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Registration plate lamp insecure (1.1.C.1c)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)