2000 Mercedes-benz Clk

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings floor (6.1.B.2)

Offside Headlamp aim too far to the left (1.8)

Nearside Front Steering pivot point has slight play (2.2.B.1g)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement n/s and o/s (2.4.G.2)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement n/s and o/s (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake fluctuating, but not excessively n/s and o/s (3.7.B.3)

rear brake fluctuating, but not excessively n/s and o/s (3.7.B.3)

Brake pipe excessively corroded leading to nearside rear flexi hose (3.6.B.2c)

Brake pipe excessively corroded leading to offside rear flexi hose (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Wheel bolt(s) missing (4.2.A.1e)

Nearside Rear Sub-frame rubber bush deteriorated resulting in excessive movement front bush (2.4.G.2)

Nearside Rear Wheel bolt(s) missing (4.2.A.1e)

Nearside Seat belt anchorage prescribed area is excessively corroded floor pan marked yellow (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wing area (2.4.A.3)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Wheel bolt(s) missing (4.2.A.1e)

Offside Front brake caliper inappropriately repaired spring not fitted in (3.5.1n)

Offside Rear Sub-frame rubber bush deteriorated resulting in excessive movement front bush (2.4.G.2)

Offside Rear Wheel bolt(s) missing (4.2.A.1e)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

offside floor pan corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Headlamp deteriorated but light output not reduced nearside and offside (1.7.5a)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Rear Shock absorber has slight corrosion to the casing nearside and offside (2.7.2a)

Rear coil spring corroded nearside and offside (2.4.C.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

eml light on

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

rear wheels odd

Offside Front Wheel bolt(s) missing (4.2.A.1e)

rear wheels odd

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

offside rear tyre has nail in tread