2000 Mazda MX-5

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

vehicle has been undersealed

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Tyre slightly damaged/cracking or perishing sidewall (5.2.3 (d) (ii))

Offside Rear Nail in tyre ()

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive general underbody (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

exhaust emisions only just met catalytic converter strugling to work properly

both rear lower suspension arms corroded

Front registration plate character(s) incorrectly spaced (6.3.4a)

both rear lower suspension arms corroded

Front Inner brake disc worn, pitted or scored, but not seriously weakened surface corroding (3.5.1i)

Offside Front Inner Brake pad(s) wearing thin (3.5.1g)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Rear Brake pipe excessively corroded nearside to offside (3.6.B.2c)

rear brake application uneven (3.7.B.2)

Parking brake lever has little reserve travel (3.1.6b)