2000 Honda Hr-v

Front Upper Exhaust mounting defective (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Upper Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Front Lower Engine mounting damaged but not to excess (6.1.8 (a) (i))

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Drive shaft which forms part of the suspension excessively corroded (2.4.G.4a)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Play in steering rack inner joint(s) Both ()

Prop shaft center bearing corroding

Front Front position lamp(s) incorrect colour both (1.1.A.3e)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front position lamp(s) incorrect colour both (1.1.A.3e)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre(s) incorrect because a lightweight or space saving wheel is fitted (4.1.A.1b)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

rear antiroll bar corroding

slight play in O/S/R droplink

nearside front tyre has cut in sidewall [ cords not exposed ]

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)