2000 Honda Prelude

Front Shock absorber has slight corrosion to the casing all front suspension components have slight corrosion (2.7.2a)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Inner Vehicle structure has slight corrosion inner sills (6.1.B.2)

Offside Rear Inner Vehicle structure has slight corrosion inner sill (6.1.B.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Vehicle structure has slight corrosion whole underside (6.1.A.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' stone chip (8.3.1d)

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner and outer sills (5.2.6)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner and outer sills (5.2.6)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

corrosion to both front chassis legs

plastic sill covers fitted

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

corrosion to sills / floor pan rear chassis legs

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

corrosion to sills / floor pan rear chassis legs

both the ABS and 4WS lights were illuminated but then turned off which would indicate a possible fault

exhaust system is corroded

wheel trims are fitted to all roadwheels so I am unable to check the wheel nuts/bolts etc

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too low (1.8)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Headlamp aim too low (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear wheel steering inoperative but rear wheels are held substantially in the straight ahead position and the steering is not adversely affected (2.2.B.1j)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear wheel steering inoperative, not affecting front wheel steering

Nearside Registration plate lamp not working (1.1.5c)

Offside Registration plate lamp not working (1.1.5c)

Rear wheel steering inoperative, not affecting front wheel steering

unable to see brake pipes due to covers †unable to see sill panels due to covers

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Centre stop light inoperative.