2000 Peugeot 106

Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s)

Rear Shock absorber has a slightly worn bush (2.7.4)

Rear Torsion bar slight play at an end fixing (2.4.E.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside driveshaft retaining nut not secured

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front drive shaft coupling is excessively worn (2.5.C.1c)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Play in steering rack inner joint(s)

Rear Shock absorber has a slightly worn bush (2.7.4)

Rear Torsion bar slight play at an end fixing (2.4.E.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside driveshaft retaining nut not secured

Fuel system component leaking (7.2.3)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Front position lamp(s) insecure (1.1.A.3a)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Front constant velocity joint is insecure (2.5.C.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Body has slight corrosion (6.1.B.2)

Items removed from driver's view prior to test

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Oil leak

engine light on

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Play in steering rack inner joint(s)

all brake pipes greesed

mot carried out in wet conditions

rear bumper damaged

surface rust on front discs appears to been stood

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Play in steering rack inner joint(s)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

all brake pipes greesed

mot carried out in wet conditions

rear bumper damaged

surface rust on front discs appears to been stood

Front front brake juddering slightly (3.7.A.2b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Play in steering rack inner joint(s)

battery insecure

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Front front brake juddering slightly (3.7.A.2b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Play in steering rack inner joint(s)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

battery insecure

Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake discs worn

inbalance on front brakes

near side rear brake efficancy low

nearside rear tyre cracking

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Spare wheel carrier insecure (6.4.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake discs worn

inbalance on front brakes

near side rear brake efficancy low

nearside rear tyre cracking

Parking brake: efficiency below requirements (3.7.B.7)

Rear Spare wheel carrier insecure (6.4.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front suspension has excessive movement at a suspension ball joint (2.5.A.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Service brake: efficiency below requirements (3.7.B.7)

n/s/r tyre perishing and starting to split

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front front brake application uneven (3.7.B.2)

Offside Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front constant velocity joint is slightly worn (2.5.C.1b)