2000 Ford Puma

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement mounting (5.3.4 (a) (i))

Nearside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement mounting (5.3.4 (a) (i))

Exhaust deteriorated

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

High level stop light not working

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive Nearside and offside (5.3.6 (a) (i))

Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Nearside and offside (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive Nearside and offside outer/inner sills (7.1.1 (a) (i))

advise rear silencer corroded (no leaks)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

advise rear silencer corroded (no leaks)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded axle mounting point (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Headlamp aim too high (1.8)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

high level brake light inoperative

rear exhaust silencer out skin is corroded

underside of vehicle has general corrosion

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

high level brake light inoperative

rear exhaust silencer out skin is corroded

underside of vehicle has general corrosion

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Vehicle structure has slight corrosion (6.1.B.2)

front and rear sub frames surface corrosion

tail box corroded not blowing

Centre Stop lamp not working (1.2.1b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Vehicle structure has slight corrosion (6.1.A.1)

corroion on rear axle beam

surface corroion front engine bed

tail box corroded not blowing

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

exhaust rear box corodded not blowing

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Fluid suspension unit leaking (2.4.D.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)