2006 Toyota MR2

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

brake disc worn, pitted or scored, but not seriously weakened all 4 (3.5.1i)

engine light on

Front Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake lever has no reserve travel (3.1.6b)

brake disc worn, pitted or scored, but not seriously weakened all 4 (3.5.1i)

engine light on

Parking brake lever has little reserve travel (3.1.6b)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight visable smoke at high rpm

Emissions not tested (7.0)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s front wheel bearing noisy

o/s rear wheel bearing noisy

full underside inspection could not be carried out due to manufactureres underbody shields

Offside Rear position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Rear Registration plate lamp not working (1.1.C.1d)

Rear fog lamp tell tale not working (1.3.1b)

full underside inspection could not be carried out due to manufactureres underbody shields

n/s front wheel bearing noisy

o/s rear wheel bearing noisy

Park brake lever free travel in need of adjustment

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Parking brake lever has no reserve travel (3.1.6b)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear brake disc excessively pitted (3.5.1h)

Parking brake lever has no reserve travel (3.1.6b)

front brake pads are getting low

n/s/r brake disc is rusting