2000 Mercedes-benz E

Front Sub-frame corroded and seriously weakened crossmember (5.3.3 (b) (i))

Nearside Rear Inner Position lamp not working (4.2.1 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Body has an unsafe modification wing sharp edges (6.2.1 (d) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Body has an unsafe modification wheel arch sharp edges (6.2.1 (d) (i))

Offside Rear Brakes imbalanced across an axle weak (1.2.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill to wheel arch (7.1.1 (a) (i))

Sub-frame pin or bush excessively worn front bushes on rear (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases joint (7.1.2)

front brake fluctuating, but not excessively both (3.7.B.3)

rear brake fluctuating, but not excessively both (3.7.B.3)

Brake hose excessively deteriorated both front flexible (3.6.B.4d)

Brake hose excessively deteriorated both rear flexible (3.6.B.4d)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords in treads (4.1.D.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Central Exhaust has a minor leak of exhaust gases joint (7.1.2)

front brake fluctuating, but not excessively both (3.7.B.3)

rear brake fluctuating, but not excessively both (3.7.B.3)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)

rear exhaust heatshield insecure

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Centre Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate has a feature which changes the appearance or legibility of the characters (6.3.4c)

Rear registration plate has a feature which changes the appearance or legibility of the characters (6.3.4c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Rear position lamp(s) not working (1.1.A.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

slight imbalance on n/s rear service brake

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

both registration plates starting to deteriorate

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Inner Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

low tone horn inop

srs light on