2000 Mercedes-benz Sprinter

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Horn not working (1.6.2a)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Body or chassis is cracked, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear position lamp(s) incorrect colour (1.1.A.3e)

Nearside Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) incorrect colour (1.1.A.3e)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Body has a projection caused by damage (6.1.C.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Diff noisy!!

Both rear hub seals leaking

Near-side outer seat belt slow to retract

lift lower ball joints

oil leak n/s/r hub

tail pipe corroded

lift lower ball joints

rack getting stiff

wet test

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Lower Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

front disc worn

front tyres worn edges

lift lower ball joints

Front Brake hose slightly deteriorated (3.6.B.4d)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear brake disc slightly pitted (3.5.1h)

ENGINE BELLY PAN FITTED

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

ENGINE BELLY PAN FITTED

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

lift in offside and nearside front lower suspension ball joints just acceptable