2001 Mitsubishi Lancer

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Windscreen damaged but not adversely affecting driver's view Crack (3.2 (a) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member (6.1.1 (c) (i))

Offside Front Service brake lagging in operation (1.2.1 (d))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 28% (1.2.1 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Wheel binds when rotated by hand

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Wheel binds when rotated by hand

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Exhaust mounting defective rubber missing (6.1.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Brake disc contaminated corroded (1.1.14 (b))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake disc contaminated corroded (1.1.14 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust mounting defective rubber missing (6.1.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases cat (6.1.2 (a))

Front Integral body structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases cat (6.1.2 (a))

Front Integral body structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front wheel bearing not tested

Central Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Central Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Rear Brake pipe slightly corroded across axle (3.6.B.2c)

Central stop lamp not working

Front Subframe mounting prescribed area is corroded but not considered excessive cross member (2.4.A.3)

Nearside Front Lower Suspension arm damaged but not seriously weakened section has been cut to allow room for anti roll bar link design fitted (cut obviously in past as surface of cut area corroded over) (2.4.G.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Front Lower Suspension arm repaired, but not inappropriately suspension arm appears new but has contact with anti roll bar link which may slightly restrict free movement as arm corrodes naturally & increases in skin depth (2.4.A.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear coil spring corroded (2.4.C.1b)

Power steering component(s) has slight seepage from a seal steering rack (2.3.3b)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear fog lamp not working (1.3.2b)

Central stop lamp not working

Front Subframe mounting prescribed area is corroded but not considered excessive cross member (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Power steering component(s) has slight seepage from a seal steering rack (2.3.3b)

Initial fast idle test failed.

Nearside Rear Vehicle structure has slight corrosion chassis member (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion chassis member (6.1.B.2)

Centre Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cross member,by lateral engine support (6.1.B.2)

Centre Rear Upper Stop lamp not working (1.2.1b)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Initial fast idle test failed.

Nearside Rear Vehicle structure has slight corrosion chassis member (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion chassis member (6.1.B.2)

Corrosion starting at rear chassis, near to suspension mounting.

Centre Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

rear seat lifted to check seat belt

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rattle from front exhaust shields

front exhaust pipe heat shield corroded

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

fuel filler pipes corroded

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Rear brakes slight grab

Temporary fuel cap fitted

Brake load sensing valve linkage seized (3.6.E.3)

Offside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Rear brakes slight grab

Temporary fuel cap fitted

Nearside Front Tyre worn close to the legal limit (4.1.E.1)