2000 Honda Prelude

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Fuel Pipe/s corroded filler to tank ()

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear brake disc in such a condition that it is seriously weakened excessive heat (3.5.1i)

Nearside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Fuel Pipe/s corroded filler to tank ()

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has small hole in it

Heavy surface rust to underside of vehicle

both front tyres wearing on edges

slight bind to the offside rear brake

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

slight brake bind to the offside rear

both rear tyres wearing slightly on edges

Front Tyre worn close to the legal limit (4.1.E.1)

Offside front brake juddering slightly (3.7.A.2b)

brake disc slightly pitted (3.5.1h)