2015 Mazda Bongo

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicle undersealed

Exhaust has a major leak of exhaust gases At centre silencer (6.1.2 (a))

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Crossmember under radiator corroded/holed (6.1.1 (c) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner and outer sills holed (6.1.1 (c) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill holed (6.1.1 (c) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Central Exhaust mounting defective (6.1.2 (a))

Emissions near limit

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Exhaust has a major leak of exhaust gases centre to rear and poor condition (6.1.2 (a))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Inner Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Inner Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Oil leaking excessively from transmission (8.4.1 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Central Exhaust mounting defective (6.1.2 (a))

Emissions on limit

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. borderline (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill in centre outwith any load bearing point (6.1.1 (c) (i))

Nearside Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill in centre outwith any load bearing point (6.1.1 (c) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill in centre outwith any load bearing point (6.1.1 (c) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Rear wiper blade torn

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Lower Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components