2000 Mercedes-benz Sprinter

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill to cab step has corroded through and very spongy/ soft (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired inner sill next to spring mount, has a previous weld repair that has failed and further corrosion above repair (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill to cab step has corroded through and is very soft surrounding it (7.1.1 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis leg next to front sub frame mounting has corroded throug on top and at side, (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced offside and nearside inner and outer sills are corroded (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material offside and nearside pipes to flexi hoses and to and from load sensing valve are corroded (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced cross member behind bumper is corroded (6.1.1 (c) (i))

Rear Tyre slightly damaged/cracking or perishing offside and nearside tyres are cracking at edge of tread (5.2.3 (d) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material pipes at junction just to rear of subframe (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material pipe that meets flexi hose above axle (1.1.11 (c))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced front of chassis (6.1.1 (c) (i))

Rear Prop shaft bearing has slight play (6.1.7 (b) (i))

vehicle has had various weld repairs which are covered in underseal

Front Headlamp aim not tested unable to test with incorrect beam pattern (4.1.2 (b))

Front Horn not working (7.7 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect no beam pattern possibly incorrect or incorrectly fitted bulb (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner rear quater within 30 cm of spring mount (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to outer sill within 30 cm of leaf spring mount (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect no beam pattern possibly incorrect or incorrectly fitted bulb (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear inner quater within 30cm of spring mount (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure tyre has a cut or tear in side wall deep enough to expose cords (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure tyre has a lump on its sidewall which has cracks deep enough to expose cords (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material pipes at junction on subframe are slightly corroded (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge tyre is worn on inner edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material pipe to flexi hose is slightly corroded (1.1.11 (c))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner cab step is corroded within 30 cm of seat belt mounting (6.1.1 (c) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive chassis is corroded within 30 cm of subframe mounts (5.3.6 (a) (i))

Brake load sensing valve linkage defective but function not impaired (1.1.17 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust system corroded

Brake load sensing valve linkage defective but function not impaired (1.1.17 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust system corroded

Nearside Rear Road wheel more than one fixing loose (5.2.1 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

all suspension proponents corroded

Brake hose slightly chafed All front and rear (1.1.12 (b) (i))

Front Suspension arm ball joint has slight play Both sides (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Hub oil seal has a small leak of oil

Prop shaft bearing has slight play (6.1.7 (b) (i))

Rear Suspension component pin or bush slightly worn Shock absorbers . Also casings are corroded (5.3.4 (a) (i))

Some under body corrosion

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch inoperative (4.5.3 (a) (ii))

Brake hose slightly chafed All front and rear (1.1.12 (b) (i))

Front Suspension arm ball joint has slight play Both sides (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Hub oil seal has a small leak of oil

Prop shaft bearing has slight play (6.1.7 (b) (i))

Rear Suspension component pin or bush slightly worn Shock absorbers . Also casings are corroded (5.3.4 (a) (i))

Some under body corrosion

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

underside of vehicle & suspension components have slight corrosion

Brake hose slightly deteriorated all (3.6.B.4d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Shock absorber has a slightly worn bush (2.7.4)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

n/s/f shocker dust cover damaged

n/s/r shocker dust cover deteriated

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Steering system fouling (2.2.D.2a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Steering column universal joint has excessive play (2.1.5)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

o/s/r tyre void of tread on outter edge

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

o/s/r tyre void of tread on outter edge

Nearside Inner Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Inner Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Outer Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Inner Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Inner Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Outer Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too high and too far to the left. (1.8)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a) DANGEROUS

Offside Front Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS