2000 Suzuki GZ125

wear/play in clutch lever pivot

buckle rear wheel rim

exhaust noisey

massive wear/play in gear lever pivot

play/wear in cushdrive assy

slight bind rear brake

slight play head bearings

slight play rear wheel bearing

stand pivots very worn & insecure

tank neck & seal in poor condition

throttle assy not properly fitted but secure

Brake locking device missing (3.2.A1e)

Brake pedal has inadequate reserve travel (3.1.3b)

Brake pedal pivots excessively worn (3.1.3a)

Drive chain excessively loose (6.2.1d)

Drive chain sprocket carrier worn to excess (6.2.1e)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Headlamp aim too low (1.6)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front Footrest insecure (6.2.1a)

buckle rear wheel rim

chain & sprockets worn & slack

massive wear/play in gear lever pivot

slight play & roughness in rear wheel bearing

stand pivots very worn & insecure

tank neck & seal in poor condition

throttle assy not properly fitted but secure

wear/play in clutch lever pivot

Rear Brake cable slightly corroded (3.2.A1b)

Rear Brake pedal pivots slightly worn (3.1.3a)

Front Headlamp aim too low (1.6)

Rear Registration plate with character(s) which are not the correct height (6.3.4a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake cable slightly corroded (3.2.A1b)

Rear Brake pedal pivots slightly worn (3.1.3a)

chain tension slightly tight

slight buckle to both wheels(had repair)

Front Wheel has an excessively distorted bead rim. (4.2.2)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Wheel has an excessively distorted bead rim. (4.2.2)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Horn control not functioning. (1.7.2b)

Rear Brake lining(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Drive chain excessively loose (6.2.1d)

Rear Drive chain worn to excess (6.2.1e)

Rear Roller brake test indicates a sticking brake (3.3.A1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Front Motorcycle structure slightly damaged (6.1.1a)

Offside Front Brake master cylinder insecurely mounted (3.2.B1a)