2000 Audi Tt

Front Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Anti-roll bar ball joint dust cover severely deteriorated both front (5.3.4 (b) (i))

Front Drive shaft joint constant velocity boot severely deteriorated both front outer (6.1.7 (g) (i))

Rear Coil spring corroded rear both (5.3.1 (b) (i))

Front Anti-roll bar ball joint dust cover severely deteriorated both front (5.3.4 (b) (i))

Front Drive shaft joint constant velocity boot severely deteriorated both front outer (6.1.7 (g) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Coil spring corroded rear both (5.3.1 (b) (i))

Front Anti-roll bar ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Outer Drive shaft joint constant velocity boot severely deteriorated both sides (6.1.7 (g) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Anti-roll bar ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Outer Drive shaft joint constant velocity boot severely deteriorated both sides (6.1.7 (g) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Traction control light on

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear registration plate character(s) not correctly formed (6.3.4b)

Registration plate lamp not working (1.1.C.1d)

Traction control light on

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Side repeater not working (1.4.A.2c)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Rear Discs in poor condition

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Inner Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

rear suspension ride hight/ headlamp adjuster broken.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear coil spring fractured (2.4.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

o/s/f lower suspension arm rear mounting bush bonding is seperating

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Surface rust on ns and os rear brake disc.